Controlling spindle with a GS2: Modbus or 10V ?

This Section is for users to discuss hardware

Controlling spindle with a GS2: Modbus or 10V ?

Postby GaryLa » Mon Jan 13, 2020 10:47 pm

I got another UC300 to put on my lathe. I have a GS2 2HP VFD from Automation Direct. I use Modbus to configure it, but I've not tried to run it via Modbus.

I was wondering if anyone had an opinion as to whether: if they had the choice, would they run it via the 0-10V typical interface, or use the Modbus?

I have UCCNC 1.2111

Thanks in advance.
GaryLa
 
Posts: 67
Joined: Thu May 30, 2019 11:30 pm

Return to Hardware

Who is online

Users browsing this forum: No registered users and 2 guests