No plasma jet when THC is on

This is the place to talk about and share things related to CNC plasma machines using UCCNC

No plasma jet when THC is on

Postby P0ppy » Thu Jan 27, 2022 6:54 pm

God bless You,
When I have set up Mach3 to use Proma THC 150, plasma torch stopped cutting material even if I turn it on manually by clicking F5. Previously torch had worked.
What should I change in Mach3 configuration to troubleshooting?
Best regards,
P0ppy
P0ppy
 
Posts: 9
Joined: Tue Jan 25, 2022 3:45 pm

Re: No plasma jet when THC is on

Postby P0ppy » Fri Jan 28, 2022 1:48 pm

P.S.: I use AXBB-E to control plasma cutter.
P0ppy
 
Posts: 9
Joined: Tue Jan 25, 2022 3:45 pm

End of thread

Postby P0ppy » Mon Feb 07, 2022 1:11 pm

God bless You,
I have found solution. Relay for torch hasn't been working, so it gets replaced with another one. Torch is working now.
Sincerely,
P0ppy
P0ppy
 
Posts: 9
Joined: Tue Jan 25, 2022 3:45 pm


Return to CNC Plasma

Who is online

Users browsing this forum: No registered users and 5 guests