Re: Anyone know if Neuron forum is dead ???
Posted: Wed Jan 09, 2019 11:06 am
Andrew,
I'll try to list the problems or issues
Ok, so I installed the uccnc dropbox folder to a clean / new install of UCCNC.
I used the /p NeuronPlasma switch so that the profile starts.
As I am at work at the moment, my PC is running in Demo Mode, and I select UC400 (I have a UC400 and a UC300ETH), Keith is running a UC400ETH. So I presume most users of the neuron will be running either a UC300ETH or a UC400ETH, but I guess you could also use a UC100 if you REALLY wanted to give it a go.
Back to the issue.... load UC400ETH motion controller.
And I am presented with this screenset.
(1) I am presented with a "Start Axis Reference" Message box {from the constructor macro}
For the neuron LITE this should not be needed?
So, can we just delete all content of the constructor macro M99998?
(2) I presume that the Cyrillic text button is for the LASER? (next to the TEST button)
(3) All of the LED's below the toolpath window have no text denoting what they are?
I presume we have the wrong background loaded for the UC400ETH motion controller / screenset.
(4) The THC Response Slider has been removed, are we not able to use this to fine tune the profile?
Now when I go to close down UCCNC I am presented with this Cyrillic ??? message box which is from the deconstructor macro.
Given I have a Neuron Lite, I presume that this is not required and I can delete all of the text within the M99999 macro?
I'll try to list the problems or issues
Ok, so I installed the uccnc dropbox folder to a clean / new install of UCCNC.
I used the /p NeuronPlasma switch so that the profile starts.
As I am at work at the moment, my PC is running in Demo Mode, and I select UC400 (I have a UC400 and a UC300ETH), Keith is running a UC400ETH. So I presume most users of the neuron will be running either a UC300ETH or a UC400ETH, but I guess you could also use a UC100 if you REALLY wanted to give it a go.
Back to the issue.... load UC400ETH motion controller.
And I am presented with this screenset.
(1) I am presented with a "Start Axis Reference" Message box {from the constructor macro}
For the neuron LITE this should not be needed?
So, can we just delete all content of the constructor macro M99998?
(2) I presume that the Cyrillic text button is for the LASER? (next to the TEST button)
(3) All of the LED's below the toolpath window have no text denoting what they are?
I presume we have the wrong background loaded for the UC400ETH motion controller / screenset.
(4) The THC Response Slider has been removed, are we not able to use this to fine tune the profile?
Now when I go to close down UCCNC I am presented with this Cyrillic ??? message box which is from the deconstructor macro.
Given I have a Neuron Lite, I presume that this is not required and I can delete all of the text within the M99999 macro?