forum.cncdrive.com

hello all,

i got a used xhc hb04 usb handwheel today. i enabled the plugin, all the buttons work fine. however turning the handwheel, the table only moves in one direction, no matter if i turn clockwise or counterclockwise.

is this an issue with the plugin or did i got a broken handwheel. i am using version 1.2113 on windows 7, win7 driver is installed correctly.

my x box controller works just fine.
thanks,
michael

There is no such problem with the plugin, nobody reported such issue, so it is likely an issue with the pendant.
Maybe get a UCR201.

i was contemplating getting the UCR201. thanks for the info.