forum.cncdrive.com

I've asked this before but not in the feature request section

Can we have an M10/M11 checkbox, same way as m205/m206, m207/m208, m209/m210, m211/m212 works please on the configuration screen tab please.

It will allow me to keep track of whether it's enabled or not other than monitoring the port+pin for the laser output

Thanks as always

.... if we can't do a checkbox, LED etc as it would take too long to edit all the screensets....

what about an exec. variable {same as exec.M3on ... M4on.... M7on .... M8on ..... etc}