Coordinate rotate ( G68 G69 )
Posted:
Wed Sep 14, 2016 7:10 amby Robertspark
G68 rotate coordinates
G69 cancel coordinate rotation
bit of info here
http://www.cnccookbook.com/CCCNCGCodeG68G69CoordinateRotation.htm(does not appear to be RS274, but Fanuc )
Re: Coordinate rotate ( G68 G69 )
Posted:
Mon Dec 18, 2017 6:48 pmby X3msnake
Please implement this
We need this to do auto edge detection and work alignment, I could write a simple macro for my stepcraft probe if this was implemented.
https://www.youtube.com/watch?v=amWolMgEM-Qhttps://www.youtube.com/watch?v=5j8GJGqLztU
Re: Coordinate rotate ( G68 G69 )
Posted:
Wed Dec 20, 2017 11:37 pmby cncdrive
This is already implemented.
Re: Coordinate rotate ( G68 G69 )
Posted:
Wed Dec 20, 2017 11:42 pmby X3msnake
cncdrive wrote:This is already implemented.
Great
How / where can we get the new update
Re: Coordinate rotate ( G68 G69 )
Posted:
Wed Dec 20, 2017 11:45 pmby cncdrive
From the UCCNC software's webpage on our website:
http://cncdrive.com/UCCNC.htmlAnd it is not a new update, it was implemented about half year ago.
Re: Coordinate rotate ( G68 G69 )
Posted:
Thu Dec 21, 2017 1:02 pmby X3msnake
cncdrive wrote:From the UCCNC software's webpage on our website:
http://cncdrive.com/UCCNC.htmlAnd it is not a new update, it was implemented about half year ago.
Greetings
Ok I have checked and in my version 1.2037 G68 does not work neither is listed in the support Gcodes.
You say it was implemented in the middle of the year so I would assume it was in this version?
What am I doing wrong?
Re: Coordinate rotate ( G68 G69 )
Posted:
Thu Dec 21, 2017 1:09 pmby X3msnake
Ok I installed Version 1.2047 and i see it in the supported Gcodes and it works on MDI
I missed this update because there is no changelog post on the Log forum anouncing this update :\
Re: Coordinate rotate ( G68 G69 )
Posted:
Thu Dec 21, 2017 1:14 pmby cncdrive