seperate m3 for laser

Here is where you can request new features or special features.

seperate m3 for laser

Postby Battwell » Fri Nov 01, 2019 10:27 pm

putting a laser on a router as an add on- to both be able to be used in the same profile is pretty awkward at the moment.
using m3 which is trying to switch both spindle and laser on at the same time.
and should analog still be coupled to pwm when laser engrave plugin is in use?

for laser a seperate m3 output would be desirable. and ignore spindle on delay.
Uc300eth on router and mill
If they say it can't be done- I find a way!
Battwell
 
Posts: 545
Joined: Sun Sep 25, 2016 7:39 pm
Location: South Wales. Uk

Return to Feature Request

Who is online

Users browsing this forum: No registered users and 2 guests