As per the title.... anyone know of a way to put a comment in the status box?
i thought it may be a field or something similar but I cannot see it.
I use messagebox quite a lot, but I've got a a macro for a plasma torch touch off using a shared input for the floating head and the ohmic probe, and I'd like to add a message to the status box to say that there is an ohmic probe problem (but I don't want to use a message box or stop the programme as I can still use the floating head).
(the problem is commonly crud in the torch tip which shorts out the ohmic cap to the torch, the macro tests for this before starting the probing routine, and if the input is active, it drops the relay out for the ohmic probe and just uses the floating head touch off) ... hence no need to stop the machine for me as the machine will set either the ohmic / floating head offset according to which is triggered) I can clean the tip / replace the tip for the next job .... but it would be nice to see something in the status box
I'll post the code late for anyone to use / learn from
Thanks in advance for your time + guidance