Page 4 of 4

Re: MPG Pendant Macro help request

PostPosted: Tue Aug 29, 2017 2:48 pm
by Dale
I can redo the PCB to have Independent signals for each button if that helps. I have unused wires in the cable. Seeing as I now have a UC300 Motherboard, I now have lots of inputs unlike before. I'll just have to reconfigure my BOB for more inputs and rewire the pendant with a new PCB.

Let me know if this would help.
BTW, Thank you both for your efforts here. Very much appreciated. Can't wait to be able to use the pendant again.
Once you've gone pendant, theres no going back! ;)

Dale

Re: MPG Pendant Macro help request

PostPosted: Tue Aug 29, 2017 2:58 pm
by Robertspark
That but I think I'm ok with reading the pins

Let me have a go at some code this evening (couple of hours) see where I get to

Re: MPG Pendant Macro help request

PostPosted: Tue Sep 05, 2017 12:13 pm
by Dale
Hello?

Re: MPG Pendant Macro help request

PostPosted: Tue Sep 05, 2017 12:53 pm
by dezsoe
Hello! :)

I didn't forget you, just had an urgent job and ran into a problem with reading all the keys. I will tell you if I have any results.

Re: MPG Pendant Macro help request

PostPosted: Tue Sep 05, 2017 12:55 pm
by Dale
Thanks for the update, and for helping me out here.

Cheers!

Dale

Re: MPG Pendant Macro help request

PostPosted: Fri Jul 06, 2018 1:03 am
by Dale
Once again....

Thanks for all your help. :roll: :roll: :roll:

Re: MPG Pendant Macro help request

PostPosted: Tue Sep 10, 2019 11:56 pm
by Dale
Never heard back from any of you.
Was it something I said?

Just using my pendant with limited functionality, but man it’s nice to use even as is.

Dale

Re: MPG Pendant Macro help request

PostPosted: Thu Sep 12, 2019 8:39 am
by dezsoe
OMG, it was 2 years ago... I'll try to refresh my memory. There were so many urgent jobs since then.