linear tool change macro
Posted: Sun Nov 24, 2019 8:20 pm
i can not find the macro for the type of tool changer i have,
i have 10 tool holder clips along the x axis with tools in them, you have to position above the needed tool, open chuck , drop on it, close chuck, and pull out on the y axis to get tool.
i have attached this photo , bottom left photo is what i have
i have 10 tool holder clips along the x axis with tools in them, you have to position above the needed tool, open chuck , drop on it, close chuck, and pull out on the y axis to get tool.
i have attached this photo , bottom left photo is what i have