Setting analog output

[Battwell]

Setting analog output- pointers?
I need to set the output from a macro
Increasing until movement is detected by a sensor on spindle motor. Then zeroed again as fast as possible
Tried Setanalogoutput(1);

[cncdrive]

If it is a controller with an analog output (UC300ETH) then you can attach a #var to the analog output channel.
There is an option for that on the Configuration-I/O setup page, the "#var -> analog out x" setting is that.
You select the #var number to attach to and then when you set the value of that variable the analog output will go to the voltage level proportional to the value.

[Battwell]

It’s a Uc300eth
That makes it easier than the way I’ve done it today!

[cncdrive]

We've tried to make it as simple as possible.